Inceptions High Flow Open Face designs combine decades of
paintball bolt technology into the most advanced Autococker bolt design ever.
If you need to replace your bolt or want a drop-in upgrade that will improve your
marker’s performance, the V2 HF Open Face bolt is a must have.
Optimized Design
Inception’s High Flow Open Face bolts are machined from Delrin. The lightweight, self-lubricating material has less mass than an aluminum bolt. The bolt features slots to further reduce its weight and cut down on friction in the bolt bore. The HF Open Face bolt is the perfect solution if you’re looking to reduce the weight and see an improvement in marker performance.
The HF Open Face Bolt features an anti-stack-clipping
chamfered front. The design helps reduce barrel breaks, especially with the smaller
paint that has become so common in the modern age of paintball. The bolt does
not have a soft rubber tip – it’s open face after all! The bolt does have a front
sealing o-ring, as well as valve port o-rings, so it’s extremely air-efficient.
The HF Open Face Bolt also features a gas path that is
port-matched to the hole through the marker body and angled and optimized for
efficient air flow throughout the bolt. The result is increased velocity, shot
consistency, and air-efficiency over any other bolt.
The HF Open Face Bolt even has a timing hole for perfect Allen
key clearance. You won’t need to remove the bolt to adjust your hammer lug.
Ultra-Compatible
Inception wanted to make sure you could use the HF Open Face
Bolt on as many markers as possible.
The bolt includes two sets of o-rings that allow you to
match it to your marker’s bore. The smaller o-ring set is primarily for use
with older generation markers, while the larger o-rings are ideal for use with
modern markers. The bolt also has side and top bolt pin holes, so it can be
used with either style of back block. Finally, the HF Open Face bolt has detent
slots milled into both sides of its body, so it’s compatible with all detent types.